Search found 108 matches

by TG2891
Fri May 16, 2008 11:24 pm
Forum: Powertrain
Topic: Crank bearing
Replies: 9
Views: 432

Just started looking but how do you get the stator side crank bearing out? There does not seem to be a place to get a good grip to pull or press out, or am I missing something? Also, if I am in there should I replace the balancer shaft bearings too? They do not look or feel bad but what is everyones...
by TG2891
Fri May 16, 2008 11:18 pm
Forum: Powertrain
Topic: Finding Netural
Replies: 7
Views: 246

So hit the detent lobe with a 5/8 dremel sand drum, how much of a improvment is this? 10k/in off?
by TG2891
Wed May 14, 2008 2:58 am
Forum: Cannondale Quads
Topic: clutch adjustment
Replies: 3
Views: 322

Can anyone tell me the proper way to adjust the hydraulic clutch. <br />From the manual - Hold the outer ring with cer-clip pliers, loosen the lock nut, screw in the adjustment bolt, back out 3 full turns and then tighten the lock nut.<br />OK well the question is how far do you screw in the adjustm...
by TG2891
Wed May 14, 2008 2:39 am
Forum: Powertrain
Topic: Finding Netural
Replies: 7
Views: 246

Red Line. Smurf blue low shock gear oil.
by TG2891
Wed May 14, 2008 2:06 am
Forum: Powertrain
Topic: Finding Netural
Replies: 7
Views: 246

Finding netural is tough, Is there a fix for making it easier to find netural.
by TG2891
Sun May 11, 2008 2:56 pm
Forum: Maintenance
Topic: Cold Surge
Replies: 10
Views: 1062

Ok call me a dumb A**, Problem solved. OLD GAS!!!! Thanks for all your help and ideas though. I was told to check that when I talked to Dave and that was the first thing he mentioned. Hard headed I guess. Any way, Thanks again.

TOM
by TG2891
Sun May 11, 2008 5:17 am
Forum: Maintenance
Topic: Cold Surge
Replies: 10
Views: 1062

Tried unpluging the temp sensor. Cleaned the idle stepper motor and lubed it. Neither worked. I swapped a stepper motor from my blaze it semed to be working but by then the motor was hot. I will let you know.

TOM
by TG2891
Sun May 11, 2008 4:44 am
Forum: Maintenance
Topic: Cold Surge
Replies: 10
Views: 1062

And yes it is stock with the (I think) 432cc piston.
by TG2891
Sun May 11, 2008 4:43 am
Forum: Maintenance
Topic: Cold Surge
Replies: 10
Views: 1062

Not Sure as I got it used and set the values by exhaust temp, smell and plug inspection.
by TG2891
Sun May 11, 2008 3:23 am
Forum: Maintenance
Topic: Cold Surge
Replies: 10
Views: 1062

I will give that a try. <br />I also called someone else and asked them and they suggested that the stepper motor was sticking. I pulled it out and lubed it but it still is doing the same thing. <br />I will try the coolant sensor but I think it is working properly. When I monitor the motor on the l...