Cannondaleriders

Nitrided? Are you sure?<br /><br />They look more like 'Tuftrided', Nitriding normally leaves them with a silver finish... <br /><br />Nitriding goes much deeper too, around .010" typically, so is not a 'skin' to flake off and cause bearing problems.<br /><br />Tuftriding leaves...

Here's a (pretty poor quality) pic of my younger daughter Emily (now 13) jumping over her brother Jake (now 17) on her 250 Sportrax...

I think its going to be difficult to get them done for $100, to be honest. <br /><br />I would be pretty surprised if that can be done, especially over here....<br /><br />The strength of the pound against the dollar will probably make it much less expensive to do it over there I think....<br /...

And possibly.......<br /><br /><br /><a href="http://www.bosch-motorsport.de/pdf/components/injection_valves/EV_6.pdf" target="_blank">http://www.bosch-motorsport.de/pdf/compone...valves/EV_6.pdf</a><br /><br />or....<br /><br /><a href="http://www.bosch-motorsport.de/pdf/components/injection_valves...

Ah, so much the same as my Jet-Skis used to do if I kept the throttle pinned when landing off jumps. The motor would rev out then be rapidly slowed by the sudden in-rush of water and the flywheel would fail, much like hitting the brakes mid-air I suppose. <br /><br />The first signs was that the pow...

OK, thanks for that.

Anyone have any pics of the broken bits?

It's called 'Point du Vaux'. It's a proper international endurance event. It's possibly the biggest quad race in the world. <br /><br />A company just 30 mins from me, 'ATV World' in Leeds, usually win it with either a YFZ450 or a Banshee. They tend to enter about four or...

Ok, along with a heap of other stuff to try to create solutions for I have turned my attention to the flywheel.... <img src="http://www.cannondaleriders.com/forums/style_emoticons/<#EMO_DIR#>/blink.gif" style="vertical-align:middle" emoid=":blink:" border="0" alt="blink.gif" /> <br /><br />Now I hav...

Don't forget that our injectors spray at about 15 degrees off the centreline of the injector in the direction of the connector.....<br /><br />This is so the fuel goes nicely down the port rather than onto the port wall as it first appears it would....<br /><br />If you look at the injector tip ...

<!--quoteo(post=172511:date=May 20 2007, 04:16 AM:name=cannondale27)--><div class='quotetop'>QUOTE (cannondale27 @ May 20 2007, 04:16 AM) <a href="index.php?act=findpost&pid=172511"><{POST_SNAPBACK}></a></div><div class='quotemain'><!--quotec-->Flywheels<!--QuoteEnd--></div><!--QuoteEEnd-->...