Cannondaleriders

Shhh, Steve....

I was at Ed's shop today and he still has a few sets available.
They just need to be powder coated.
Call this week or next, because he's going to the Indy show the following week.
Teixeira Tech 209-833-9160

I also have a couple of used plates, if you still need one.

I know some WORCS racers. All run mx suspensions with 20" rears and 21" fronts. Never heard of any width issues. The trail sections are usually plenty wide enough for a standard mx width 49-50".<br />Note that they will be enforcing sound rules this year. Pros are supposed to be at 96...

Get a hold of Canniboomer. He may have some pics.
I just bought a complete lever, master and slave setup from him.
He warned me that pulling the lever with the slave cylinder not mounted can damage the slave cylinder.

What does the motor have done to it?

Never mind, I found your post.

What are you looking to get for the motor?

Merry Christmas!!

And big thanks to everyone on the site for their help and support throughout the year!

That's what it will take to get some innovation in exhaust technology.<br />Funny thing about WORCS, Hollister Hills has been on their schedule the past several years, and it has by far the toughest noise enforcement. But they dropped it from the 09 schedule. So, maybe they think it is going to ...

CA has a 96dB limit at the State run SRVA's but the private tracks are not limited, unless they are near housing.<br />We run a series that is 90% on private tracks, but one of favorite tracks is Hollister Hills GP and there we all have to come down 99dB or lower. Thank fully it's only twice...

I have a used LT set of ASR +2, camber/caster adjustable a-arms that use 18-1/2" LT shocks(like the moto ohlins from C27). I think I can round up most if not all 8 new heim joints for the arms. I also have an assortment of of used ASR tie rods as well. I may have new ball joints too. I'll c...