Cannondaleriders

Best to apply a small amount of some type of o ring grease like di electric ect. And install with a slight twist. The o ring helps seat the injector in the bung of the manifold throat and the. Clips keep the injector in place.

Anyone know what happened to R&S Performance? Are they still in business?

New ones are available. Have have several sets here all are used but in good shape. Low on nuts and studs tho.

Unsure of the metric size the part# is 5001545

The injector hold downs should hold injector. May be a little sprung. Also check the nut on the hold down studs to ensure its still there and tight.

O ring may have swelled best to replace and apply a very small amount of di electric grease before installing bung.

That's correct. It's caused by shorting the positive and negative on the fuel pump by means of arcing off the ground to either the frame or fuel pump itself. A rubber boot is a must on the negative side on the fuel pump. The circuit that controls the fuel pump in the ecu is fried more than l...

What you have there is a falicon stroker crank. The upper rod journal does not take a bearing, the wrist pin is a slip fit into there. There have been known cases to press a bushing in there ONLY if the surface was unsalvagable. The z400 bearing is the lower rod bearing. I'm not to sure if falic...

Awesome vids. Cannondale sounds good who built your engine?

I'm trying to find a set of early FX400 cams.
Thank you