Search found 1276 matches
- Mon Apr 23, 2007 3:21 pm
- Forum: Open Forum
- Topic: An afternoon at Motoland
- Replies: 23
- Views: 1238
I always keep my two middle fingers on the clutch......and practice that way...and after abvout 5-6 practices my arm doesnt tense up and im able to do it a whole race......because im always needing to slam the rear break in air or feather it to control sliding through corners. But on bumpy straight ...
- Thu Apr 19, 2007 3:10 am
- Forum: Open Forum
- Topic: NEED SOME HELP HERE
- Replies: 12
- Views: 174
I measured the piston again using a digital micrometer and from the top of the wrist pin whole to the deck of the piston reads .612(approxiamtely) and the JE reads .667 so the JE is taller by a few thousands. My dad measured the pistons the first time and he over looked that the wiseco still have th...
- Wed Apr 18, 2007 4:07 pm
- Forum: For Sale
- Topic: '03 Moto for sale or trade
- Replies: 21
- Views: 1608
- Wed Apr 18, 2007 4:40 am
- Forum: R&D
- Topic: The X pipe
- Replies: 54
- Views: 2259
- Mon Apr 16, 2007 5:00 pm
- Forum: Open Forum
- Topic: NEED SOME HELP HERE
- Replies: 12
- Views: 174
- Sun Apr 15, 2007 2:41 am
- Forum: Open Forum
- Topic: NEED SOME HELP HERE
- Replies: 12
- Views: 174
- Sat Apr 14, 2007 3:47 pm
- Forum: Open Forum
- Topic: NEED SOME HELP HERE
- Replies: 12
- Views: 174
I was, but then i made a deal with Doug to trade my used short rod falicon for a new z400 updated stock crank and new sleeve/piston. But i havnt heard back fom him and im assuming that deal went sour.<br /><br />And now im moving and need to get this engine back together before i move soo im going t...
- Fri Apr 13, 2007 3:01 pm
- Forum: Open Forum
- Topic: NEED SOME HELP HERE
- Replies: 12
- Views: 174
- Fri Apr 13, 2007 4:33 am
- Forum: Open Forum
- Topic: NEED SOME HELP HERE
- Replies: 12
- Views: 174
I need some serious help with bore/piston height measurements.<br /><br /><br />I have a short rod crank...FALICON........with a WISECO piston that came out of it. <br /><br />NOW...the piston measures .667 of an inch from the top of the wrist pin hole to the top of the piston deck...............and...
- Thu Apr 12, 2007 8:23 pm
- Forum: Wanted
- Topic: looking for an old supertrapp muffler
- Replies: 6
- Views: 183