Cannondaleriders

kdeal was so bummed about not seeing the head work stand in billet I thougt I would cheer him up with this simple rotating engine build stand I whipped up with my mad waterjet skills. I know it probably is not as fancy as the factory one he probably has but in works pretty well. The tray catches the...

The bike only maps do not have a command on for the cooling fan since the bike does not have that... there is a few hybrid maps that have the qualities of the x. Will try to load a couple here.

I would pull out the crank trigger sensor and make sure a bunch of metal filings have not collected on the magnet and swap it or maybe there is something goofy with the flywheel... if you have not done that allready.

check the wires that go to the clutch switch or just bypass them by tying them together. Also could be your start button or the solenoid down by the battery... the small wires going into that are notorious about breaking where they go into it. If you need another one there are a couple of different ...

Put a volt meter on the battery terminals to make sure you have at least 12.6 or higher if it is fully charged. Then hit the start button and see what it does to if it goes below 9 volts cranking or not it is done. The quality of batteries these days has gone into the dump especially with what is co...

It is the cannibal map that is giving you fits because you are ported so it is lean when the throttle is at the idle position. They tend to need more fuel at idle when ported. Another thing that can cause this is a small exhaust leak at the head pipe... make sure that is still tight.<br />I have not...

It might help to explain what the benifit is for someone to have this for their cannondale. Exactly what it does and what you need to do after it is added.<br />I do not think anybody really explained that well and I have been on here a long time so maybe that has a little something to do with why t...

Good to hear from probably one of the most mechanically intelligent former real contributers to the endeavor here! Sorry to have seen you move on but thank you for your contributions while you were here!<br />Good to see that your collection may stay intact and benifit another good member ov...

Did you happen to load a map without going into the update calibrations and switching them over to what you got from reading the previous calibrations instead of what automatically comes from the map? Sometimes the flow rate that automatically populates from the new map is a dangerously low and lean...

Went last week with the whole setup but for thanksgiving I may be down with a quad in a pickup and ride saturday and sunday.
Not sure where just yet.