Cannondaleriders

How do you find your stock leakage for setting with the ECU DIAG cable? Is it on the dyno sheets?

Jason

Thanks for your help kdeal.

Jason

How do you check this and if it is how do I fix it.

Thanks,
Jason

OK, I have my factory numbers. Now starting over, can someone tell me what to do to get my atv going using the ECU DIAG cable. Any sugjestions on a map for a stock cannibal? I ride in the woods 100% and am not really looking at raising the RMP's much.

Thanks,
Jason

Can someone lookup my VIN#. I need my stock numbers. The Vin# is 5B6FD31G23B000213.

Thanks,
Jason

What would cause the brake pads to drag on the front right side. I check my rotor and it is not warped. Any ideas?

Thanks,
Jason

Here is my VIN# 5B6FD31G23B000213. If you guys can help me it will greatly appreciated.

OK, so I need some help. My stock setting are gone. I did not write them down (did not say to in the directions I was following). It starts good when it is cold but once it warms up you you go to restart you have to crank on it for a little bit. It use to start right up any time I would kill it or h...

I was able to get it running. I think I am good now. I loaded to 03 Cannibal map and set my open and close throttle position. I did not mess with the flowrate, leakage and offset. When I opened the map these items were already filled in. Do I need to adjust these settings?<br /><br />***AZCANNON - b...

I need help in a bad way. I have an 03 LE Cannibal. It was running good but I thought it was time to do a throttle calibration. I purchased an ECU DIAG cable and tried to adjust my TPS. I am having issues and would like to find someone that I can call that will help walk me through this...<br /><br ...