how to remove graphics easily?

Message

ozarkdaler · #1 Post by **ozarkdaler** » Wed Apr 04, 2007 10:16 pm

Hey guys,

I am planning on taking off my jividens graphics and putting on some new ones. I was wanting to know what is the best/easiest way to remove the old garphics and making sure the plastic is clean to install the new ones.

Thanks in advance.

wright · #2 Post by **wright** » Thu Apr 05, 2007 1:30 am

I would say a heat gun but dont get it to hot, and some carb cleaner or they might just peal right off with out the heat gun?

tat · #3 Post by **tat** » Thu Apr 05, 2007 3:06 am

Hair dryer for lower heat and WD-40. The heat gun would be a nice stand by if the dryer doesnt give u enough.

Easy E · #4 Post by **Easy E** » Thu Apr 05, 2007 4:53 am

Heat gun on low setting - it only takes a few seconds to soften the glue, so don't get carried away.