I'd say something is wrong here.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
So I got these and I thought something was wrong when they stacked together perfectly. Maybe I'm blind, but to me both seem to be for the right or throttle side of the quad. The seller says I'm just installing them wrong. He must think installing air shrouds is rocket science. Please take a look and tell me if I'm wrong...or right I guess. Excuse the messy garage floor, it's cold, wet, and windy here today. Everything keeps blowing right into the garage.
[attachment=6334:scoop1.JPG]
[attachment=6335:scoop2.JPG]
[attachment=6336:scoop3.JPG]
[attachment=6337:scoop4.JPG]
[attachment=6338:scoop5.JPG]
[attachment=6334:scoop1.JPG]
[attachment=6335:scoop2.JPG]
[attachment=6336:scoop3.JPG]
[attachment=6337:scoop4.JPG]
[attachment=6338:scoop5.JPG]
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I already have. He can't seem to find one. All the links are expired. I've searched all the cannondale sites too and can't seem to find a pic of the UM scoops installed. It's a reputable seller, I guess thats why he thought he could tell me I was wrong. I still haven't heard back from him, but it's a long holiday weekend, so I'll give him some time.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (thedeatons @ May 24 2008, 02:21 AM) <{POST_SNAPBACK}>
I forget, did your Glamis have an aluminum cam cover?
They look like the same sides to me. I bought stainless shrouds for my wife's old Z400, and they were opposite of each other. Like you said, not rocket science.
They look like the same sides to me. I bought stainless shrouds for my wife's old Z400, and they were opposite of each other. Like you said, not rocket science.
I do not have an aluminum cam cover. At least I haven't put one on. That is on my list. My wife is going to nashville for 2 weeks starting tomorrow, so I am going to completely tear it down this next week and get some powder and polishing done. the motor is being yanked out then and I will go through it and make sure everything is good to go and the crank will be sent out. I have found a lot of nasty looking hardware so far. Kinda sad. I am beginning to see that the previous owner did not take very good care of this machine. Oh well. I'll get her fixed up nice.
thanks for all the help gentlemen. I trully appreciate it. I'll keep you updated on what happens with these scoops.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm