Fullbore

Message

airtime · #11 Post by **airtime** » Wed Sep 24, 2003 3:09 pm

that sure looks nice. is it narrower by the gas tank than the factory plastic? i know there is atleast 2 to 3 inches between the frame and the factory plastic by the gas tank sides.

moto-rider-7 · #12 Post by **moto-rider-7** » Wed Sep 24, 2003 4:17 pm

it's narrower by the gas tank feels better turning just all around better feeling if you can get a deal on fullbore go for it

airtime · #13 Post by **airtime** » Mon Sep 29, 2003 8:28 pm

something on my riding gear has ripped my factory seat cover on the driver side middle seaction. right at the bottom, after riding hard saturday, i noticed something was digging into my butt. after i got home i found several scratches on my lower butt and found three very sharp hard plastic studs in my seat, i guess they are used to hold down the seat foam. anyway, will a seat cover and a small peice of foad fix this or will i need a new seat foam and cover. also, i where is the best place to get a gripper seat cover?

OCR · #14 Post by **OCR** » Mon Sep 29, 2003 10:09 pm

love the look of the orange fullbore