nerf bars

Message

candyassmiler · #1 Post by **candyassmiler** » Fri Oct 03, 2003 2:15 am

bought a pair of ac's.....how do i put them on? :clap:

JST · #2 Post by **JST** » Fri Oct 03, 2003 2:35 am

It depends on what model you have.I have a early FX and we had to drill out the frame holes below the battery,then slide the shafts in.As far as drilling into the foot pegs,good luck extremly hard stainless steel.Have a titanium drill bit or 2 ready and be patient,do not force the bit or it will break,we learned this one the hard way.

Psychosis · #3 Post by **Psychosis** » Fri Oct 03, 2003 3:03 am

I had trouble w/this myself and have a message from a few months back w/pics on how to do it.

http://forums.cannondaler.com/viewtopic.php?t=797

Sandstorm · #4 Post by **Sandstorm** » Fri Oct 03, 2003 3:44 am

If they are just the nerfs and not the propegs I slide them in the frame holes, fasten them to lower frame then use vise grips and pull them against the pegs. Put the top of the nerfs just below the lowest part of the teeth on the pegs or even 1/16th lower. I used a small bit for my pilot hole and then went to a bigger bit. It tooK me 20 minutes to drill my holes.