installing graphics

Message

guthrie08 · #1 Post by **guthrie08** » Wed Feb 02, 2005 8:20 pm

are there any special procedures so i dont end up with a ton of air bubbles, thanks

bowhunter74 · #2 Post by **bowhunter74** » Wed Feb 02, 2005 10:00 pm

Spray them down with soap and water, slide them around where you want them, push out the bubbles and let them dry. This works out very nice.

Cdale_racer_669 · #3 Post by **Cdale_racer_669** » Thu Feb 03, 2005 3:38 am

Sticker ON from denniskirk works great also. put nail polish around the edges to keep them from peeling!

cdalemx301 · #4 Post by **cdalemx301** » Thu Feb 03, 2005 2:20 pm

never done it but i know the shop i go to a lot uses windex on the back of the graphix cuz it will dry itself out after