Page 2 of 2
plastic
Posted: Wed Sep 24, 2003 3:09 pm
by airtime
that sure looks nice. is it narrower by the gas tank than the factory plastic? i know there is atleast 2 to 3 inches between the frame and the factory plastic by the gas tank sides.
Posted: Wed Sep 24, 2003 4:17 pm
by moto-rider-7
it's narrower by the gas tank feels better turning just all around better feeling if you can get a deal on fullbore go for it
seat cover
Posted: Mon Sep 29, 2003 8:28 pm
by airtime
something on my riding gear has ripped my factory seat cover on the driver side middle seaction. right at the bottom, after riding hard saturday, i noticed something was digging into my butt. after i got home i found several scratches on my lower butt and found three very sharp hard plastic studs in my seat, i guess they are used to hold down the seat foam. anyway, will a seat cover and a small peice of foad fix this or will i need a new seat foam and cover. also, i where is the best place to get a gripper seat cover?
Posted: Mon Sep 29, 2003 10:09 pm
by OCR
love the look of the orange fullbore