pro design kill switch from ex fit cannibal??
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
no it wont work on your dale
theres no way of puting it on if you do its just gona fry your pcm.
the dale needs a normaly open
where the 400ex was a normaly close .
on the dale the kill switch is closed and to kill the motor you open the switch .
where on the 400 . the kill switch is open and it closes to ground.
theres no way of puting it on if you do its just gona fry your pcm.
the dale needs a normaly open
where the 400ex was a normaly close .
on the dale the kill switch is closed and to kill the motor you open the switch .
where on the 400 . the kill switch is open and it closes to ground.
Yeah, just get the pingle or the new setup off of the 03's. The Pingle is nice, but I've found 2 problems with them. The nut likes to come loose, and the switch will not work then, and the wire connections corrode(SP) at the connections at the unit after several washings. I siliconed the connections and used blue loctite on the washer.
THe Pro Design is a bad idea. The break of circut is backwards for the Dale. The only way to make it work is to ground out the system. And I've seen it fry ECU's and pop fuses. I think the Pingle is $50, but it's worth it. Just plugs right in.
THe Pro Design is a bad idea. The break of circut is backwards for the Dale. The only way to make it work is to ground out the system. And I've seen it fry ECU's and pop fuses. I think the Pingle is $50, but it's worth it. Just plugs right in.