Cannondaleriders

Posted: **Wed Apr 04, 2007 10:16 pm**

Hey guys,

I am planning on taking off my jividens graphics and putting on some new ones. I was wanting to know what is the best/easiest way to remove the old garphics and making sure the plastic is clean to install the new ones.

Thanks in advance.

Posted: **Thu Apr 05, 2007 1:30 am**

I would say a heat gun but dont get it to hot, and some carb cleaner or they might just peal right off with out the heat gun?

Posted: **Thu Apr 05, 2007 3:06 am**

Hair dryer for lower heat and WD-40. The heat gun would be a nice stand by if the dryer doesnt give u enough.

Posted: **Thu Apr 05, 2007 4:53 am**

Heat gun on low setting - it only takes a few seconds to soften the glue, so don't get carried away.

Cannondaleriders

how to remove graphics easily?