stainless tophats

Message

pcleiter · #11 Post by **pcleiter** » Wed Aug 25, 2010 10:26 pm

Definately can use some, too.

cannondale27 · #12 Post by **cannondale27** » Thu Aug 26, 2010 12:38 am

It would be cool to have them as big dia as possible, so I don't have to use washers on the stock size to keep old plastic they wore through going a little longer.

Speed 1B · #13 Post by **Speed 1B** » Sun Aug 29, 2010 4:15 am

Im in for a couple sets also.

cdsracer · #14 Post by **cdsracer** » Mon Aug 30, 2010 2:58 pm

I need two sets (at least)

wistech · #15 Post by **wistech** » Tue Aug 31, 2010 11:47 pm

Dirty Tony says the shop will do them at around 25 cents for metal and $1.75 each to cut but the price is negotable with volume.
Im thinkin look for a stepped bolt like what honda uses and be done with it.

Happyboy · #16 Post by **Happyboy** » Wed Sep 01, 2010 12:47 am

I can get more sets done if needed. I guess I just need a good count and can get more made up. Way cheaper than the $2 a piece, way way cheaper. John, can you link me a pic of the stepped bolt you are talking about?

cannondale27 · #17 Post by **cannondale27** » Wed Sep 01, 2010 1:15 am

Dzus fastners would be the best especially for front.

cannondale27 · #18 Post by **cannondale27** » Wed Sep 01, 2010 2:07 pm

How about these?Interest?Will have these at group ride.Not cheap though.Probably about $3-5 each with grommets.
[attachment=10536:Plastic_Screws.jpg]

wistech · #19 Post by **wistech** » Wed Sep 01, 2010 11:41 pm

The tophats that are on the clutch springs can also be used on plastic as they are almost identical to the short ones.

wistech · #20 Post by **wistech** » Thu Sep 02, 2010 12:15 am

Here are the clutch tophats and the honda stepped bolt.