Page 1 of 1
Posted: Sat Jul 24, 2010 11:46 pm
by Z4J
Been looking a the Rocky Mountain's metal heel guard selection. Was hoping to get something close and have a friend weld/fab. to fit. Has anyone done any research on this? Suzuki, Honda, Yamaha, KTM, ect..... any close to the fit of the plastic guards Cannondale designed or just order and start fresh? Thanks.
Posted: Sun Jul 25, 2010 4:07 pm
by rayspeed
The only aftermarket heel guards I have seen have been attached to nerf bars...
Posted: Sun Jul 25, 2010 6:07 pm
by Z4J
OK. I think all I've seen lately is the ACs with the guards attached. I'll do a little more research and see if there's anything close. Otherwise I get Neal from CFM Performance to give me a hand with al. welding & fab.
Posted: Sun Jul 25, 2010 10:10 pm
by speedracer
I have tried heel guards off a Z-400 and a Banshee,you can rule both of them out,not even close.
Posted: Sun Jul 25, 2010 10:35 pm
by Z4J
*CHECK*
The No-Goes-
Z400
Banshee
I think I have some stock 400EX somewhere. I'll check those tonight.
Posted: Mon Jul 26, 2010 3:39 am
by rayspeed
I have some AC's with the full aluminum heel guards all in good shape I would probably be willing to part with.
Posted: Wed Jun 13, 2012 6:20 pm
by werty
Hate to bring up a old topic ... any new ideas for the heel guards?
Posted: Thu Jun 14, 2012 6:53 am
by beanie$440$peed
Hate to bring up a old topic ... any new ideas for the heel guards?
Just got good shape ac ones for 100$.i would keep searching for ac cannondale ones