Wide grab bars and bumpers
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (2000ex @ Oct 1 2010, 07:23 AM) <{POST_SNAPBACK}>
That is an ac no doubt. Not to hijack this thread, but anyone know about the front bumpers? I am looking for a prm summit bumper. I may need to buy one for a yfz if they do in fact fit.
You're not hijacking. I asked about them in the first post. I am thinking about a bumper from Pro Armor if some other quad is a close fit.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (quadracer500 @ Oct 2 2010, 06:32 PM) <{POST_SNAPBACK}>
I found these guys on the web looks like ac copies.
www.protectfabrications.com/Cannondale.htm
www.protectfabrications.com/Cannondale.htm
Good find! They have a pic of a speed with a copy of the grab bar I want.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I went ahead and took some measurements. If any of you have other machines, could you take a look and see if any are close to these?
The top mount was 7 3/8" wide. The bottom mount was 5 3/8" wide. The 2 mounts are 5 3/8" from center to center. And the way that I tried to figure the slope wasn't entirely accurate or even the right way but its all I had to work with at the time. I stood a level up on its end and put a carpenter square against it. The top hole is about 3 or 4 degrees back from the bottom vertical centerline.
I know for sure that the 400ex and the 300ex bumper will not work.
The top mount was 7 3/8" wide. The bottom mount was 5 3/8" wide. The 2 mounts are 5 3/8" from center to center. And the way that I tried to figure the slope wasn't entirely accurate or even the right way but its all I had to work with at the time. I stood a level up on its end and put a carpenter square against it. The top hole is about 3 or 4 degrees back from the bottom vertical centerline.
I know for sure that the 400ex and the 300ex bumper will not work.