Wide grab bars and bumpers

Message

cannondale27 · #11 Post by **cannondale27** » Fri Oct 01, 2010 3:39 am

I was just kidding Jess!Make a offer.

jesshamner · #12 Post by **jesshamner** » Fri Oct 01, 2010 3:49 am

Yeah I know Steve. Thanks for the offer but I'm holding out for a PRM or an equal clone. If I can't find one, I may come a-knockin. <---Kentucky talk.

cannondale27 · #13 Post by **cannondale27** » Fri Oct 01, 2010 3:51 am

Ok.I may test it for you then

Z4J · #14 Post by **Z4J** » Fri Oct 01, 2010 9:24 am

Steve...shoot me a price please.

2000ex · #15 Post by **2000ex** » Fri Oct 01, 2010 11:23 am

That is an ac no doubt. Not to hijack this thread, but anyone know about the front bumpers? I am looking for a prm summit bumper. I may need to buy one for a yfz if they do in fact fit.

jesshamner · #16 Post by **jesshamner** » Fri Oct 01, 2010 11:50 am

QUOTE (2000ex @ Oct 1 2010, 07:23 AM) <{POST_SNAPBACK}>

That is an ac no doubt. Not to hijack this thread, but anyone know about the front bumpers? I am looking for a prm summit bumper. I may need to buy one for a yfz if they do in fact fit.

You're not hijacking. I asked about them in the first post. I am thinking about a bumper from Pro Armor if some other quad is a close fit.

quadracer500 · #17 Post by **quadracer500** » Sat Oct 02, 2010 10:32 pm

I found these guys on the web looks like ac copies.

www.protectfabrications.com/Cannondale.htm

jesshamner · #18 Post by **jesshamner** » Sat Oct 02, 2010 10:54 pm

QUOTE (quadracer500 @ Oct 2 2010, 06:32 PM) <{POST_SNAPBACK}>

I found these guys on the web looks like ac copies.

www.protectfabrications.com/Cannondale.htm

Good find! They have a pic of a speed with a copy of the grab bar I want.

jesshamner · #19 Post by **jesshamner** » Tue Oct 26, 2010 2:08 am

Update, the yfz front bumper isn't anywhere near the same as a Cannondale. The top mounting points are about an inch too tall and both top and bottom are about 2 inches (1" on each side) too narrow.

Here is a mockup of the IMS though.

jesshamner · #20 Post by **jesshamner** » Tue Oct 26, 2010 2:22 am

I went ahead and took some measurements. If any of you have other machines, could you take a look and see if any are close to these?

The top mount was 7 3/8" wide. The bottom mount was 5 3/8" wide. The 2 mounts are 5 3/8" from center to center. And the way that I tried to figure the slope wasn't entirely accurate or even the right way but its all I had to work with at the time. I stood a level up on its end and put a carpenter square against it. The top hole is about 3 or 4 degrees back from the bottom vertical centerline.

I know for sure that the 400ex and the 300ex bumper will not work.