Page 1 of 1
lights
Posted: Tue Dec 07, 2004 10:53 pm
by guthrie08
when removing your rear tail-lights, do you disconnect it below the gas tank or take the whole assembly off, and also for adding deletes the one bracket holds the fuse and other switch, do you guys mount these somewhere else. and when disconnecting head-lights you just disconnect them or take the whole assembly/wires out, thanks.
Posted: Tue Dec 07, 2004 11:10 pm
by speedy911
when i removed my rear taillight. i removed the wire harness with it.
Posted: Tue Dec 07, 2004 11:43 pm
by cannondale27
Me too.When you remove your headlights put the spacer back in the bracket and tighten it this will prevent the tab on the frame for the front fender braces from breaking off.If your not running full fenders then you could get rid of all of it.
Posted: Wed Dec 08, 2004 8:50 pm
by guthrie08
alright thanks but where do you mount the fuse and other switch thats on the left headlight support bracket.
Posted: Wed Dec 08, 2004 9:11 pm
by kdeal
You are going to leave the bracket on to mount the headlight bushings. This triangle will keep the frame tabs from breaking. So you don't need to move the fuse.
Posted: Wed Dec 08, 2004 10:52 pm
by guthrie08
alright thanks, for those who removed the whole rear tail-light assembly, where it connected to the main wires, under the engine, how did you disconnect it from in there?
Posted: Wed Dec 08, 2004 10:56 pm
by speedy911
no from the connector on the subframe