Pingel kill switch install

Message

fyrmedic · #11 Post by **fyrmedic** » Fri Jul 09, 2004 11:13 pm

removed the on/off switch alltogether. Unpluged both bullet connectors, crimped connectors on red/blue kill switch wires, pluged them into on/off harness, works great!

fyrmedic · #12 Post by **fyrmedic** » Fri Jul 09, 2004 11:16 pm

oops.. brain working faster than my 2 fingers can type! Plug red/blue wires into wire harness where the on/off switch came out.

MI_CDALE_Rider · #13 Post by **MI_CDALE_Rider** » Mon Jul 12, 2004 8:36 pm

Checked out my wiring, cut into one of the factory on/off wires just below the front plastic level. Then I went to Rat shack and they were helpless, no bullet type connectors or even a clue as to what they are. I picked up some terminal push together type end and soldered them together, taped, heat shrunk, then taped again, tucked under the front plastic!

Happyboy · #14 Post by **Happyboy** » Tue Jul 13, 2004 2:06 am

Exactly what I did!

MI_CDALE_Rider · #15 Post by **MI_CDALE_Rider** » Tue Jul 13, 2004 9:51 am

QUOTE

Originally posted by Happyboy
Exactly what I did!

And it seemed to work really well!