Posted: Fri Jul 09, 2004 11:13 pm
removed the on/off switch alltogether. Unpluged both bullet connectors, crimped connectors on red/blue kill switch wires, pluged them into on/off harness, works great!
Cannondaleriders
A safe place for quads older than the owners
https://cannondaleriders.com/phpbb/
Pingel kill switch install
https://cannondaleriders.com/phpbb/viewtopic.php?f=11&t=6117
Page 2 of 2
Posted: Fri Jul 09, 2004 11:16 pm
oops.. brain working faster than my 2 fingers can type! Plug red/blue wires into wire harness where the on/off switch came out.
Posted: Mon Jul 12, 2004 8:36 pm
Checked out my wiring, cut into one of the factory on/off wires just below the front plastic level. Then I went to Rat shack and they were helpless, no bullet type connectors or even a clue as to what they are. I picked up some terminal push together type end and soldered them together, taped, heat shrunk, then taped again, tucked under the front plastic!
Posted: Tue Jul 13, 2004 2:06 am
Exactly what I did!
Posted: Tue Jul 13, 2004 9:51 am
QUOTE
Originally posted by Happyboy
Exactly what I did!
Exactly what I did!
And it seemed to work really well!
