anti-fade...

Message

MyCannibal · #1 Post by **MyCannibal** » Wed Jul 05, 2006 8:05 pm

My rear rotor was a lil wobbly so I removed the rubber boot on the axle to tighten up the allen heads a little and two of the three are stripped out..is there any aftermarket fix to this...like different anti-fade locknuts?...I think this is what it is called.....someone correct me if I'm wrong....

wistech · #2 Post by **wistech** » Wed Jul 05, 2006 9:05 pm

Tap the holes out to the next bigger size.

kdeal · #3 Post by **kdeal** » Wed Jul 05, 2006 9:13 pm

QUOTE (wistech @ Jul 5 2006, 05:05 PM) <{POST_SNAPBACK}>

Tap the holes out to the next bigger size.

Stock size is 4mm x 12mm long. I would go with a 5mm size.

MyCannibal · #4 Post by **MyCannibal** » Wed Jul 05, 2006 9:24 pm

thanks guys.