help

Message

justfine · #1 Post by **justfine** » Sun Jun 08, 2003 9:19 pm

I can't find a 12/32 drill bit anywhere for the moto-mount update.......what gives?

Cannibal440 · #2 Post by **Cannibal440** » Sun Jun 08, 2003 9:46 pm

Don't drill out the inserts. Tap them out using the original bolts, by backing the bolt out part way and just tap on the head of the bolt with a heavy hammer. If you don't do it this way, you also have to cut down the spacer that comes with the kit.

440 rider 34 · #3 Post by **440 rider 34** » Sun Jun 08, 2003 11:42 pm

Any hardwear store will have them, I found mine at true value hardwear.

canibalistic · #4 Post by **canibalistic** » Tue Jun 10, 2003 11:59 am

are you supposed to tap it or drill it?

440 rider 34 · #5 Post by **440 rider 34** » Tue Jun 10, 2003 12:43 pm

Im sure tapping out would work also but i drilled mine.

Jaybr · #6 Post by **Jaybr** » Tue Jun 10, 2003 1:57 pm

I think it depends on the kit. The R&S kit requires tapping out the insert, others require drilling.

canibalistic · #7 Post by **canibalistic** » Tue Jun 10, 2003 1:58 pm

THANKS!!!

justfine · #8 Post by **justfine** » Tue Jun 10, 2003 4:29 pm

Got mine from Quadsource, and it says to drill. Anybody else got thier kit from Quadsource? also as far as the bit is concerned would a 12/32 be the same as a 3/8?

cannondale27 · #9 Post by **cannondale27** » Tue Jun 10, 2003 5:32 pm

Quadsource kit you drill it.Yes 3/8 is same as 12/32.

justfine · #10 Post by **justfine** » Tue Jun 10, 2003 6:40 pm

THANKS DUDE!!!!!!! Why would they just not say 3/8?

Cannondaleriders

help

help

Which is it??

hmmmmmmm

cannondale27