Page 1 of 2
My buddies YFZ508 Falicon stroker
Posted: Mon Nov 22, 2004 3:23 am
by azcannibal
The YFZ picture is my buddies check out the spacer below the cylinder can you say "STROKED"?.....he stroked it with a Falicon crank setup....now it's a 508cc....I think I'll be just watching him from afar on my Cannibal.....OK at least till I get mine broken in.....(1 Tank of Gas should do it) then I'll keep my distance as he goes by me.
Later!
Posted: Mon Nov 22, 2004 1:30 pm
by haydug
hmmm, guess I'm not the only one to want more out of the yammie!!
Give us a report.
Posted: Fri Nov 26, 2004 4:22 am
by azcannibal
Leaving in the morning!
Posted: Fri Nov 26, 2004 4:37 am
by Sandstorm
I have seen this YFZ run personally. It is wicked fast. It is under 300lbs. This is one of the best vids I have ever seen. The racing is near the end of the vid, but it's a must see vid all the way through.. It is Utah's Sand Mtn and Made by CPCPatriot..
http://www.planetsand.com/ubbthreads/showf...rt=1#Post252887
FAST !!!
Posted: Fri Nov 26, 2004 4:51 am
by azcannibal
Thanks for the Video....keep them coming....!
Going to Buttercup in the morning!!
Got to break in my 450 before I go up against the 508cc.
Looks like I should get a dust mask! LOLs
L8R
Posted: Fri Nov 26, 2004 12:39 pm
by JST
Who built the 508?
Posted: Fri Nov 26, 2004 3:02 pm
by azcannibal
Haydug is doing some I think ....it is a falicon kit.
Posted: Fri Nov 26, 2004 8:33 pm
by cannibalq8
Falicon stroker/bore kit is ...
( 97mm ) 460bb piston kit + DD05 4mm stroker = 488c.c
Ma_ Po___ stroker/bore kit is..
( 99mm ) 480bb piston kit + DD05 4mm stroker = 508c.c
which i think ur friend and Doggriders use them.
The reason is that Falicon use (97mm ) 460bb piston kit here is that they think that going over that bore will use useless and wont gain more power.
Results
Posted: Fri Dec 10, 2004 4:18 am
by azcannibal
Been busy. Sorry for not replying in a while....the 508 dominated everything on the hill. He let me ride it. It is very controllable with the 6" over swing arm. To much $$$ for me to even say I'm going about to go that route....I am very pleased with the way my Cannibal runs...
Posted: Fri Dec 10, 2004 5:54 pm
by cannibalq8
hey azcannibal
could u tell us more details about how ur DR450 doing against Yfz508? .. coz my friend yfz looking for same ur friend 508 kit?
thanx