Pic's of your Dale
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
here it is as it sits
my subframe, beadlock rings, battery bracket, and rear hubs are all at pappy getting Pc'd TransRed
my exhaust is being polished
and my shocks were sold to a lucky z400 rider, and i picked up some elka quad rates up front and jeff@tqs rebuilt my rear ohlins with the elka rebuild
i'll have them both back this week along with my retro Fx400 plastic
then pappy will have my stuff back to me in about a week or two and i'll have the quad back together then off to champion motorsports to get big winkys crank and their 450 kit over christmas probably...
enjoy..
my subframe, beadlock rings, battery bracket, and rear hubs are all at pappy getting Pc'd TransRed
my exhaust is being polished
and my shocks were sold to a lucky z400 rider, and i picked up some elka quad rates up front and jeff@tqs rebuilt my rear ohlins with the elka rebuild
i'll have them both back this week along with my retro Fx400 plastic
then pappy will have my stuff back to me in about a week or two and i'll have the quad back together then off to champion motorsports to get big winkys crank and their 450 kit over christmas probably...
enjoy..
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
well..if that is under the knife..than i guess mine is under the chain saw yeah....i am about 2 hours or less away from having her stripped completely to the frame...my motor blew, thats being rebuilt, getting hopefully a moto LT front end..and maybe a conversion on the rear ohlins. New mx tires...hopefully new graphics, bars, number plate back grounds, and im getting some stuf PC'd a kind of flow red as well, such as: a-arms, swingarm, hubs. And then im getting these things polished and clear coated: steering stem, nerfs, bumber, and grab bar. Some of these things might not get PC'd...but almost all of them will....now heres my question for you guys, should i go th little extra mileage, and get my whole frame PC'd??????....im seriously thinking about it.....let me know, and heres some pics of her as she stands this very minute. L8er
CHAD
ohh, and in case you guys wanna know if taking the engine out was hard..........you just better take your time is all i have to say...aint horrible...but to do that you see in the picture,....took me about 7 hours(with thinking included). But it wasnt that bad.:usa
CHAD
ohh, and in case you guys wanna know if taking the engine out was hard..........you just better take your time is all i have to say...aint horrible...but to do that you see in the picture,....took me about 7 hours(with thinking included). But it wasnt that bad.:usa