QUOTE
Originally posted by pdavis
actually, i took a dana 44 from a wagoneer and put it in the front (removed IFS) but that put the center chunk on the pass side, so i had to do a little axle tube switch, dana 60 rear, 205 transfer case, the only problem i had was using the stock frame, the exhaust manifolds rested on the frame i couldnt get the motor low enough to get a real good drive shaft angle, i started building a duel 4 link setup with a full chassis, i was using a friends shop to do all the work in, than after one weekend i went to go work on my truck and everything was gone, all my welding equipment all my truck parts, all his equipment, i found out from the shop next to his that the dude moved everything over the weekend, i have never heard from him again, nobody seems to know where he went, and i must have lost $10-15,000 in truck parts and fabrication equipment,
Man that sucks!!!:furious:
Somebody needs to find that guy and :hammer: