Finished Status Light Project
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Finished Status Light Project
Well I finished my status light project. The plans were simple and worked like a charm. Here are the finished results.
.
.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I cannot take creidt for the R&D. I found the instructions on 'the other site'. But here they are:
Instructions for Cdale Status Lights in Microsoft Word
Instructions for Cdale Status Lights in Microsoft Word
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I did however locate Ladd Industries who provided all the sockets and plugs on the Cdale. I was able to order the plug and pins used so make the system very nice and clean.
Total cost was about $15. And of that the wire was $3. The light holders were another $5. The LEDs were about $4. Everything else was just change. The parts from Ladd were about $3.5 and they didn;t make me buy the $50 minimum.
And I still have enough stuff to make another one for a buddy of mine.
I mounted them there only so that I could see them while riding. And I do not have a key holder, I moved mine to the headlight bezzel.
Total cost was about $15. And of that the wire was $3. The light holders were another $5. The LEDs were about $4. Everything else was just change. The parts from Ladd were about $3.5 and they didn;t make me buy the $50 minimum.
And I still have enough stuff to make another one for a buddy of mine.
I mounted them there only so that I could see them while riding. And I do not have a key holder, I moved mine to the headlight bezzel.