QUOTE
Originally posted by 02Cannibal
The lights, holders, and resistors can all be found at radio shack. Any 4 conductor cable will do for the install. I used 4-wire telephone wire on mine. The voltage led blinks slow when below 10 volts and fast below 9 volts. The sensor light is triggered by the ECU when a sensor fault is reported. The over temp limits are actually set in the map. All the settings I've seen for the quads are 94.4 C (126.4 F) for the Marginal limit and 110.4 C (142.4 F) for the Critical limit.
Hat's off! It's an excellent instruction pack!