Durablue axle question
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Durablue axle question
Im buyin a durablue 2+2 axle from thomez:D , will my stock sprocket hub and everything else fit onto the axle??thanks alot
Matt....
Matt....
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
pretty sure you take it and press it inwards then slide the c clip out with a screw driver ( more like pry it out) then slide the hub off, thats how mine came off anyway, but it was stripped out..you may need to use a presss, or just buy a sprocket hub for them, they should make em for their x-33 axle
I have a durablue and all the stock stuff worked on it.
I got my hub off just like CdaleRacer0128 did. Gently tapped it towards the center of the axle with a rubber hammer and removed the clip. Then worked it off the axle. Mine came off just fine without using a press and at the time the quad was only about a month and a half old with about 10 hours on it.
I will say that I did have one problem after I installed it. I could not keep the axle lock nut tight. It would come loose about about 10 minutes of ride time. So I bought a LSR lock nut and haven't had any problems since.
I got my hub off just like CdaleRacer0128 did. Gently tapped it towards the center of the axle with a rubber hammer and removed the clip. Then worked it off the axle. Mine came off just fine without using a press and at the time the quad was only about a month and a half old with about 10 hours on it.
I will say that I did have one problem after I installed it. I could not keep the axle lock nut tight. It would come loose about about 10 minutes of ride time. So I bought a LSR lock nut and haven't had any problems since.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm