Jeff, I got your tie rod end boots today!

Message

JeffQuadShop · #1 Post by **JeffQuadShop** » Tue Nov 05, 2002 2:45 pm

once you pull the boot over, then make a small slit for the zerk to poke through. Then fill her up with grease!
You don't even have to mess up your toe settings to install them, just unbolt the joint from the spindel and stem, pull the bolt out of the ball, slide the boot over, reinstall the bolt into the ball, then pull the boot back over the whole thing.

Mjollnir · #2 Post by **Mjollnir** » Tue Nov 05, 2002 3:05 pm

Jeff,

From the way you describe those, they sound pretty cool. I couldn't find them on your website - can you hook it up with a pic maybe, even better a link where one might be able to order some up?

Sounds like they'd be great for keeping sand out of the sensitive bits.

Thanks,
Marc

JeffQuadShop · #3 Post by **JeffQuadShop** » Tue Nov 05, 2002 3:48 pm

here ya go bro!

JeffQuadShop · #4 Post by **JeffQuadShop** » Tue Nov 05, 2002 3:49 pm

another

cdale127 · #5 Post by **cdale127** » Tue Nov 05, 2002 5:14 pm

jeff.....send me a set:D i will call ya in a bit;)

Mjollnir · #6 Post by **Mjollnir** » Tue Nov 05, 2002 5:48 pm

Jeff, I think I would like some of them bad boys too. What's the cost, and how should I order?

Thx,
Marc

JeffQuadShop · #7 Post by **JeffQuadShop** » Tue Nov 05, 2002 7:36 pm

QUOTE

Originally posted by Mjollnir
Jeff, I think I would like some of them bad boys too. What's the cost, and how should I order?

Thx,
Marc

They are $40 for the set. Just give me a call at 502-243-0193 to order.

thanks,

Mjollnir · #8 Post by **Mjollnir** » Tue Nov 05, 2002 7:43 pm

Sweet. I'm assuming that a set consists of four. I'll be calling you as soon as I get approval from the wifey.

JeffQuadShop · #9 Post by **JeffQuadShop** » Tue Nov 05, 2002 10:00 pm

QUOTE

Originally posted by Mjollnir
Sweet. I'm assuming that a set consists of four. I'll be calling you as soon as I get approval from the wifey.

Yes sir!:cool: