Parts FAQ

[OCR]

Here is one I dont think was mentioned yet.

Guts Gripper Seat Covers

Gutscovers

[speed2424]

i just called steahlyoffroad.com at 1-800-800-2363 the puller stock no. is "E-12". price was $15.00 + shipping.
:head:

[quad_freak14]

where can i get a starter clutch cover?

[Big Winky]

I have a couple. diamond racing, 814-796-2066

[FUGITV]

heres some stuff i found out.

front hubs-400EX
front rotors-400EX

front brake calipers-DS650

rear axle bearings-250R

front spindles-400EX (must use stock inside spacer from honda)

if you run LSR arm on the front, DONT buy replacment parts from them. heres a little info i found surprising.

Upeer A-arm rod end LSR retail 23 bux!

Summit racing retail 5.95!!

1/2 inch right hand thread (male)

tie rod ends LSR retail 26 bux!

Summmit racing retail 7.95!

1/2 inch right hand, left hand thread (female)

ball joints LSR retail 26 bux!

Parts store 14.95

GM truck tie rod end!! he he he
i build drag cars, and figure if these rods ends are good enough for the 4 link on cars, they'll do JUST FINE on a 400 pound quad!!



hope this helps a few out!

[quad_freak14]

QUOTE

Originally posted by Big Winky
I have a couple.  diamond racing, 814-796-2066

I have sent you a few PM's but you wont reply???

[thomez]

He has been very busy and hasn't been online much. I talked to him on the phone last week and he had said he had neglected the forums he just didn't have time right now. Give him a call during normal business hours it will be faster and easier.

[quad_freak14]

herrmann makes LT and standard A-arms
Swingarms
Steering Stems

www.herrmannracing.com

[claas900]

..What year GM truck tie rod end??..this is for the spindle right?

[cannibal67]

Nac's is got a pretty cool graphics kit and I think alba's got graphics for cannondales too.