Page 2 of 2
Posted: Fri Apr 07, 2006 9:24 pm
by Jaybr
Slap some 400ex hubs on the rear axle and you'll be right back to stock width.
Posted: Sat Apr 08, 2006 1:16 am
by Happyboy
wish i could find some 400ex hubs sitting around. lol, all i got is cannondale crap everywhere!!
Well, went and rode this afternoon....dang it was sooo nice out. ~80 blue sky and sunny. Well, the rekluse is back to normal. Had a bad bog at dead start with full throttle that would stall me. I leaned out the bottom 5% of the map and now its a just a little bog but it doesn't stall me. I will lean it out a little more in that area tommorrow and try it again.
I did get to drag race Jermain Taylor....he was on a new YFZ Bill Ballance edition. This was before I tuned it and got rid of the stall. So, I got a bad start, had the throttle stick and still only got beat by 1/2 a quad. Not too bad I guess. Nice guy, but all they did was drag race the entire time. We hit the trails for a good 40 minutes hard and when we came out they were still over there drag racing.
Best part....little red light didn't blink an eye!!
Posted: Sat Apr 08, 2006 1:25 am
by rubicon20032003
I got some 400ex hubs with dale studs.$35 shipped,Thre need painted
Posted: Sat Apr 08, 2006 1:25 am
by BigJosh
Hey try not to mention the weather. It is very depressing when I hear abou all the good weather. We could have 75 and sunny and by midnight have snow. Just thought I would wine a bit about our weather....
Posted: Sat Apr 08, 2006 2:33 am
by Happyboy
Sorry, but not going to spend that much on a set of used 400ex hubs. I can get them on ebay for $20 shipped if I look hard enough. I would gladly take a donation though.
Racing a dale takes money!
Posted: Sun Apr 09, 2006 5:07 am
by Brad Oakley
Happy - Thanks for the advice on the PM box. Got things straightened out this evening!!!
Posted: Sun Apr 09, 2006 10:25 pm
by Happyboy
Happy - Thanks for the advice on the PM box. Got things straightened out this evening!!!
Excellent