New Small dale problem
Download the Service Bulletin here for some great pictures on the how-to:
http://www.cannondaler.com/sb.php
http://www.cannondaler.com/sb.php
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Your flow is at 1600!? What's your injector offset? I'd also get a status light kit to see if the computer is shutting down due to overheating. You'll see the staus light flash quicly and wonder if it's shutting down shortly after you hit that point. However if flow is at 1600, you couldn't be too lean unless an injector is out??
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Those numbers above sound right.
Ah ha....2600....I see. Yes, you are too lean. drop it back to the 2300-2400 range and offset should be .1 less than the factory settings to compensate for the rich condition from the factory. I'd still get a staus light kit to see if the bike runs too hot (this could indicate a lean condition) so you can shut down the engine before the ECU does. The status light kits are only around $20 if I remember correctly.
Ah ha....2600....I see. Yes, you are too lean. drop it back to the 2300-2400 range and offset should be .1 less than the factory settings to compensate for the rich condition from the factory. I'd still get a staus light kit to see if the bike runs too hot (this could indicate a lean condition) so you can shut down the engine before the ECU does. The status light kits are only around $20 if I remember correctly.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm