Posted: Thu Jan 18, 2007 6:26 pm
QUOTE (theJeStEr1340 @ Jan 18 2007, 11:05 AM) <{POST_SNAPBACK}>
I got an FMF can for mine because it was busted up for $116 off ebay. Does anyone know how to get a midpipe bent back though? Mine is bent at the curve from getting rear eneded and I am sure it is loosing some power from it.
I have been able to straighten out a ti pipe bent like yours .A special tool was required to keep from kinking the pipe and a careful hand with a torch. I actually used this pipe on the 56hp 460 motor so It must still be flowing OK. If you want I can try to fix it for you. Dont try to just bend it back or you will wreck it.