Page 2 of 7
Posted: Sat May 02, 2009 2:03 am
by peterock
small end, not the big end.
Posted: Sat May 02, 2009 3:30 am
by thedeatons
I said repair the big end because everyone has a bunch of junk rods right now because the big end is trashed. Is the big end of our current rods somehow repairable?
Posted: Sat May 02, 2009 3:50 am
by cannondale27
Winky did that. I am not willing to put something like that into my motor. When rods are shot it is normal practice to replace them. Any other way is just a shortcut.
Posted: Mon May 04, 2009 4:42 pm
by 2000ex
Pete...Count me in for one
Posted: Tue May 05, 2009 2:17 am
by thedeatons
Roger.... Thanks Steve.
Posted: Wed Jun 03, 2009 2:40 pm
by peterock
Just a heads up everyone. I plan on placing this order monday morning. Tim plans on buying some as well so we have enough to place the order. Tim is going to be sending me the exact dimensions and weights to help make sure the rods are made to the specifications we need.
Once order is placed, expect about 6-8 weeks turn around.
paypal is atkracing@sbcglobal.net
Pete
Posted: Wed Jun 03, 2009 4:34 pm
by 2000ex
Pete,
So we can run these rods on Tim's 2.2mm stroker correct? The only difference on his is the 2.2mm offset of the pin...correct?
I want to be able to rebuild the one that I just destroyed and all it needs is a rod. Thanks
Posted: Wed Jun 03, 2009 5:11 pm
by kdeal
Pete,
So we can run these rods on Tim's 2.2mm stroker correct? The only difference on his is the 2.2mm offset of the pin...correct?
I want to be able to rebuild the one that I just destroyed and all it needs is a rod. Thanks
Wes,
The rod is the same as long as it is a Timbo stroker.
Pete,
I'll take one as well.
Ken
Posted: Wed Jun 03, 2009 5:20 pm
by peterock
Thanks Ken,
Wes,
Just as Kdeal said. These rods are being made to the same dimensions as the OEM Cannondale rods.
Posted: Wed Jun 03, 2009 10:14 pm
by 2000ex
Sweet, mine got taken out by a pesky piston circlip that decided to back its way out of its groove. Made a mess