Finished Status Light Project

Message

TheJaspMan · #11 Post by **TheJaspMan** » Sun Mar 21, 2004 8:21 pm

QUOTE

Originally posted by J. Delaney
Can they be seen in the daylight?

Better than you would think. They sit far enough back into the holder that the LED is very visable even in the light.

Derno24 · #12 Post by **Derno24** » Mon Mar 22, 2004 12:47 am

I have seen the original on 02Cannibals ride. he worked the details out on this. They do show up very well in the dayligh too. You would be surprised.

Pro400EXC · #13 Post by **Pro400EXC** » Mon Mar 22, 2004 6:01 pm

Hey Boss,

Were yah be getting dem lights and holders from?

Also will they go off if there is a lil drop in temp and volts,or a major drop?

Derno24 · #14 Post by **Derno24** » Mon Mar 22, 2004 7:04 pm

Pro400: pm 02Cannibal on this site and he will answer all of your questions. He is the one that found this out. It is using what is already there. Optimum sells a kit, but wants so insane price for it. I would PM him and ask away.

TheJaspMan · #15 Post by **TheJaspMan** » Mon Mar 22, 2004 7:53 pm

PM him or check out the docs on it first. I tested it using the info from his original plans. The temp level is for a nearing danger and danger level. The same goes for the volts.

All the parts came from Radio Shack.

02Cannibal · #16 Post by **02Cannibal** » Mon Mar 22, 2004 8:22 pm

The lights, holders, and resistors can all be found at radio shack. Any 4 conductor cable will do for the install. I used 4-wire telephone wire on mine. The voltage led blinks slow when below 10 volts and fast below 9 volts. The sensor light is triggered by the ECU when a sensor fault is reported. The over temp limits are actually set in the map. All the settings I've seen for the quads are 94.4 C (126.4 F) for the Marginal limit and 110.4 C (142.4 F) for the Critical limit.

Derno24 · #17 Post by **Derno24** » Mon Mar 22, 2004 8:31 pm

I knew you would be here soon Will....

TheJaspMan · #18 Post by **TheJaspMan** » Mon Mar 22, 2004 8:41 pm

QUOTE

Originally posted by 02Cannibal
The lights, holders, and resistors can all be found at radio shack. Any 4 conductor cable will do for the install. I used 4-wire telephone wire on mine. The voltage led blinks slow when below 10 volts and fast below 9 volts. The sensor light is triggered by the ECU when a sensor fault is reported. The over temp limits are actually set in the map. All the settings I've seen for the quads are 94.4 C (126.4 F) for the Marginal limit and 110.4 C (142.4 F) for the Critical limit.

Hat's off! It's an excellent instruction pack!

02Cannibal · #19 Post by **02Cannibal** » Mon Mar 22, 2004 8:50 pm

Thanks, I'm glad you were able to use them.
Here is a pic of my installation.

TheJaspMan · #20 Post by **TheJaspMan** » Mon Mar 22, 2004 8:57 pm

That's cool. I was going to mount them in the same place. But I changed my mind on the key holder. I mounted my key in the headlight bezzel. And my kill switch is going on the top of my bars.

Are there any fancier plans or enhancments in the future?