Page 2 of 2
Posted: Tue Oct 19, 2004 12:51 am
by USAMoto00
Mine was torn down further than that just one night before the group ride.
:usa On a side note, I found those same peculiar cracks on a few people's inner frame rails. Not one side, but both.
Posted: Tue Oct 19, 2004 1:02 am
by haydug
The only problem with smacking the spindle with a hammer, is it is aluminum and will dent up easily. I loosen the ball joint nut, just to then end of the threads, use a small propane torch to heat the spindle around the ball joint, then smack the nut with a hammer while pulling. It pops right out, and your spindle still looks new.
Posted: Tue Oct 19, 2004 1:07 am
by cdalemx301
Heres the deal i do not need to sa ve my ball joints they can be destroyed the new a arms are heim joints i just need to get the spindle seperated as far as i know the threaded part is connected to the ball joint so i do not need to save this correct or does the threaded part stay on the spindle.....I have found about 5 more cracks in the swingarm now that i have pulled it off
Posted: Tue Oct 19, 2004 1:09 am
by MX Quad Dad
QUOTE
Originally posted by wanablaze A little tip Maz taught me at Socaldale: Grab a hammer and give the spindle (around the balljoint) a good whack while pulling on the a-arms. May take a few whacks, but should pop right out and you can have the job done in a couple minutes. This works well but I allways put another hammer on the opisite side you are hitting you don't have to hit it as many times or as hard. Also if you have someone to help have them put a little pressure between the knuckle and the a-arm with a prybar
Posted: Tue Oct 19, 2004 1:11 am
by bluntedMXer
well take your balls and your spindle and use your pickle fork to insert it into the axle hole using some lube...make sure to keep it tight and youll be good to ride it everynight.....im sure all u fellow riders kno what i mean...
Posted: Tue Oct 19, 2004 1:14 am
by USAMoto00
Jeez, go to Auto Zone and pay the $6 for that tuning fork or whatever it is and save your spindles from looking like sh*t. It works like butter and no banging anything! I just think you guys like whacking things with:hammer:
Posted: Tue Oct 19, 2004 2:13 am
by jfarrar
i use the hammer on mine and it hardly leaves a mark.does more damage with the fork by ripping the rubber boot.
Posted: Tue Oct 19, 2004 2:16 am
by USAMoto00
True, I have done that too. Sometimes you get lucky though.
Posted: Tue Oct 19, 2004 2:34 am
by wanablaze
If I had the time and tools required, I'd do it Doug's way. Instead I hurry up and whack it with a hammer while pulling. It does dent it a little. No assitance needed, though.
On a side note: Marc, you're right, Josh did show us that, and as Maz was leaving he showed Thomez for a second time.
:hammer: :hammer: :hammer:
Posted: Tue Oct 19, 2004 2:42 am
by cannondale27
I take two bolts using one with a nut on it and the balljoint nut still on I put the bolt in between the two studs and turn the nut from ball joint against the nut on the bolt then when tight as possible just tap spindle at joint remove the bottom one first.Repeat using the other bolt which is longer.