Moto 440 rear axle

Message

atvrulz · #1 Post by **atvrulz** » Fri Mar 07, 2003 8:12 pm

I have an 02' moto and i noticed a technical bulletin on the cannondale website where it mentions a product improvement if you install two preload disk springs. Anyone have information on doing this? whether it is necessary or not.

Redman · #2 Post by **Redman** » Sat Mar 08, 2003 3:22 am

If your quad was at the dealer at the time the bulletin came out, cannondale would/should have sent the bulletins out for every quad affected and the dealer should have put them on. I don't know the effectiveness of the bulletin or what it is it help out. Someone should now. I am possitive that R&S would have the update if you needed it.