Need ASAP Clips that go around INJ. Plugs

Message

Cannondale88 · #1 Post by **Cannondale88** » Mon Aug 29, 2005 3:23 pm

I need them little clips that go around the injecter plugs and air box sensor.....and stuff like that....need them asap, anyone have any?

wistech · #2 Post by **wistech** » Mon Aug 29, 2005 5:37 pm

If you need them asap run over to your local auto salvage yard and snag some off a car. If you can wait a few days I can send you some.

Brad Oakley · #3 Post by **Brad Oakley** » Wed Aug 31, 2005 3:51 am

I have samples in route to my shop. If they are the correct ones, I'll be carrying the clips and plugs as a regular stocking item in the near future!

blaze#52 · #4 Post by **blaze#52** » Thu Sep 01, 2005 2:05 am

a well bent paper clip will get you by in a pinch

wistech · #5 Post by **wistech** » Sun Sep 04, 2005 2:21 am

To avoid loosing ther clips dont take them off the connector. All you have to do is press gently on the center span of the wire and pull the plug off. I have had to repair dozens of these connectors because they were broken during removal. All electrical connectors are made to be removed with the human hand. the problem is there are no directions on how to do it. The coil wire is another one that can be a pain to remove. It should have a small cable tie around the center. Remove this and gently pry up on the tab with a finger nail and pull the coil plug off the coil.
88 did you get the clips yet?