Page 1 of 1
Posted: Wed Mar 07, 2007 6:57 pm
by Fash00
What are the case covers on the cannondales made out of? ALuminum or magnesium? Want to ge tmine powdercoated but need to know first
Posted: Wed Mar 07, 2007 7:14 pm
by twisted
Im only 95% sure there aluminum because people powdercoat/paint them all the time. SO giv'r.
Posted: Wed Mar 07, 2007 7:32 pm
by Smitty911
Large side cover over the timing chain in Mag. Smaller one over clutch also.
Make sure to clean it very well, bake out any oils that may be trapped and than take it to the PC.
Smitty
Posted: Wed Mar 07, 2007 8:16 pm
by thedeatons
The powdercoaters will spray on some special primer to ensure the magnesium does NOT outgas during the powdercoating process. If the magnesium does not get the primer applied, the end result will look like crap. I know because I have had three side covers done this month and some hubs.... (FYI - Front Moto hubs are also magnesium, and make sure you mention magnesium to the powder guy)
Posted: Wed Mar 07, 2007 8:57 pm
by wistech
Yep watch the front spindles to. The side covers need to be baked for sure .I boil them and then bake them. You would not believe all the crap that comes out of that metal.