Page 1 of 1
Posted: Tue Nov 05, 2002 2:45 pm
by JeffQuadShop
once you pull the boot over, then make a small slit for the zerk to poke through. Then fill her up with grease!
You don't even have to mess up your toe settings to install them, just unbolt the joint from the spindel and stem, pull the bolt out of the ball, slide the boot over, reinstall the bolt into the ball, then pull the boot back over the whole thing.
Posted: Tue Nov 05, 2002 3:05 pm
by Mjollnir
Jeff,
From the way you describe those, they sound pretty cool. I couldn't find them on your website - can you hook it up with a pic maybe, even better a link where one might be able to order some up?
Sounds like they'd be great for keeping sand out of the sensitive bits.
Thanks,
Marc
Posted: Tue Nov 05, 2002 3:48 pm
by JeffQuadShop
here ya go bro!
Posted: Tue Nov 05, 2002 3:49 pm
by JeffQuadShop
another
Posted: Tue Nov 05, 2002 5:14 pm
by cdale127
jeff.....send me a set:D i will call ya in a bit;)
Posted: Tue Nov 05, 2002 5:48 pm
by Mjollnir
Jeff, I think I would like some of them bad boys too. What's the cost, and how should I order?
Thx,
Marc
Posted: Tue Nov 05, 2002 7:36 pm
by JeffQuadShop
QUOTE
Originally posted by Mjollnir
Jeff, I think I would like some of them bad boys too. What's the cost, and how should I order?
Thx,
Marc
They are $40 for the set. Just give me a call at 502-243-0193 to order.
thanks,
Posted: Tue Nov 05, 2002 7:43 pm
by Mjollnir
Sweet. I'm assuming that a set consists of four. I'll be calling you as soon as I get approval from the wifey.
Posted: Tue Nov 05, 2002 10:00 pm
by JeffQuadShop
QUOTE
Originally posted by Mjollnir Sweet. I'm assuming that a set consists of four. I'll be calling you as soon as I get approval from the wifey. Yes sir!:cool: