She Wont start

Message

Nickc711 · #1 Post by **Nickc711** » Thu Apr 03, 2008 2:35 pm

Just rebuilt the quad....the status lights are showing a sensor fault(solid yellow light when cranking over)...im going to check for spark now...

Nickc711 · #2 Post by **Nickc711** » Thu Apr 03, 2008 2:39 pm

it has fuel also..its pissing it back in the tank...

Nickc711 · #3 Post by **Nickc711** » Thu Apr 03, 2008 3:18 pm

its getting spark....the plug didnt seem to have fuel on it though...i put some gas in on the piston....it fired for a second or two?

Easy E · #4 Post by **Easy E** » Thu Apr 03, 2008 3:27 pm

QUOTE (Nickc711 @ Apr 3 2008, 02:35 PM) <{POST_SNAPBACK}>

Just rebuilt the quad....the status lights are showing a sensor fault(solid yellow light when cranking over)...im going to check for spark now...

The yellow light will stay on until the motor starts...

Nickc711 · #5 Post by **Nickc711** » Thu Apr 03, 2008 3:47 pm

think it could be the fuel pressure regulator from sitting?

jwheat · #6 Post by **jwheat** » Thu Apr 03, 2008 6:08 pm

Make sufe you injectors are plugged in. Also the crank sensor plug and the coolant temp sensor plug are the same type of connector and are easily mixed up when installing a motor. If they are crossed then your injectors won't fire.

Nickc711 · #7 Post by **Nickc711** » Thu Apr 03, 2008 7:21 pm

that was it.....the right injector plug fell off......but it started over heating.....should i loosten the blleder on the water pump cover?

MyCannibal · #8 Post by **MyCannibal** » Thu Apr 03, 2008 7:54 pm

was the radiator and hoses completely warm?...what I do is tilt it back on the grab bar for a minute after start up to bleed it...also before you do this let it idle for a minute or two with the radiator cap off...put the cap back on then tilt it back...

Nickc711 · #9 Post by **Nickc711** » Thu Apr 03, 2008 10:20 pm

Idk if the hoses were warm...the blinking red light scared me ...lol... I also noticed it was low on oil so i need to go tomorrow and pick up some more dino oil before i will start it back up..

Do you loosen the bleeder screw when you do this?

My heartbeat is finally coming to a rest...I got to get another dale
so when im fixing one i have another to ride...lol

speed2424 · #10 Post by **speed2424** » Thu Apr 03, 2008 10:55 pm

QUOTE (Nickc711 @ Apr 3 2008, 06:20 PM) <{POST_SNAPBACK}>

.I got to get another dale
so when im fixing one i have another to ride...lol

I have 5 of them I would like to sell. Contact me when you are ready to buy.