Page 1 of 1

Posted: Fri Sep 27, 2013 1:36 am
by jesshamner
Do any of you builders leave markings or engravings on the outside of the engine after you have done work to it? Just curious.

Posted: Fri Sep 27, 2013 3:23 am
by yamadjs08
QUOTE (jesshamner @ Sep 26 2013, 08:36 PM) <{POST_SNAPBACK}>
Do any of you builders leave markings or engravings on the outside of the engine after you have done work to it? Just curious.


I know my timbo ported head has "MM" on it.



Posted: Fri Sep 27, 2013 3:25 am
by jesshamner
Where is his marking located?

Posted: Fri Sep 27, 2013 10:08 am
by SlOoT
I marked my head when I ported it.

Posted: Fri Sep 27, 2013 1:26 pm
by kdeal
If I do one, I usually mark it above the serial number on the back of the motor.