Unusual stuff I found
Perhaps a prototype quick connect fitting? An anodized aluminum oil pump drive shaft. A tall factory lug nut ? A tall tie rod end spacer? Plastic tranny spray bar and plastic oil bridge. A billet chain guide insert? There is a bunch of stuff I have yet to identify of what it actually is. Lots of spacers bushings and brackets. I did find a couple of the metal inserts for the 2 piece swingarm bearings. We used some of these a while back to build plastic bushings to ditch the junkpile of swingarm parts .
QUOTE (Wistech @ Aug 4 2015, 03:07 PM) <{POST_SNAPBACK}>
Take this for example a short clutch rod. What engine was that out of ?
Looks like that clutch push rod came out of the WJ series engines!
QUOTE (Wistech @ Aug 4 2015, 03:13 PM) <{POST_SNAPBACK}>
Here is a special prize. Ill bet this might be the only one in existance. A hand made Mil tool . The fuel selections were written with a pen. Thats crazy.
I also have a real early version sent to me from C'Dale before Kent-Moore released them and sending them out to the dealer network, almost looks the same except for the lights which were a little bigger (Will post a pic of it whenever I dig it out!), never got it to work right...along with other ones like it C'Dale claimed they were also having problems with and working on getting the bugs out!