Page 1 of 1
Posted: Fri Jan 17, 2020 8:52 pm
by wistech
Hard to tell from the pic but Im boring some throttle bodies for this year. As long as I blew the dust off the lathe I whipped up a spacer sleeve for a dual rate rear shock conversion. Even had a chance to get another set of dual exhausts started.
Posted: Fri Jan 17, 2020 8:54 pm
by wistech
Off with the zps and on with the cush.
Posted: Sun Jan 19, 2020 4:31 am
by wistech
Back to the lathe. As always Im out of finished cyclone 2 intakes so I chucked up old style one to convert it . An hour later its ready to go. I cut 3 gripping grooves in the new ones to hold on extra tight to the rubber boots.
Posted: Thu Jan 30, 2020 5:04 am
by polyesterpig
Nice to see the mad scientist is back in the laboratory!