Cannondaleriders

I will be doing a bulk batch of silver with clearcoat baked on in a couple of weeks so if any of you want to join in the price will be getting down to less than ten bucks a part easy if we can get enough pieces. It matches up to the cannon frame very well. Ive already got a stock rear axle ,steering stem and a arms done if anyone wants them. I will have some water pumps housings,side cover ,cam covers and starter cover done in this batch also. PM me for address info .

There is still plenty of time to get your stuff done. Ive only had a couple guys from this forum getting in with some covers . It doesnt have to be wheeler parts either.http:// :hammer:

What is your timetable for this? I have a set of front wheels that I could send now, but I want to sent my a-arms also. The only problem is that my racing season does not end until the 6th of December.

I guess I could do the wheels now and the a-arms later. What kind of prep work is required before powdercoating something?

I would like to have all the parts prepped and ready to go by the 15th of november and they should be able to do it in about a week after that. The parts need to be sandblasted for the best adhesion . I can blast them for you for a few extra bucks. What arms do you have because I have 2 sets of brand new cannabal ,speed arms one already silver and and one still black. We could just exchange if they could get you by. Id borrow you my long travels but they are going in this batch .