Cannondaleriders

We have come up with a quick release seat latch for the Cannondales. This is an easy to install latch without the removal of the stock seat posts.
The kit retails for $39.95 or $37.95 with the Cannondaleriders discount.
Here are a few of the steps for the install:

step 1: This one explains itself!

Step 2: Drill out the stock latch hole in the subframe to 7/16"

Step 3: Drill out the plastic to 1 1/8" We use a 7/8" unibit then use a dremel tool with a grinding wheel to open it up.

This is how big the hole should be

Step 4: Drill 1 5/32" hole at the front and one at the back of the latch hole

Step 5: Hold nylon block against bottom of subframe

Step 6: Use the supplied screws to attach nylon block to frame. Becarefull not to overtighten! Install front screw through cable eyelet

Step 7: Use blue loctite on the new post threads

Step 8: Use small screwdriver to tighten the post into the seat (I like the hole to be parallel with the quad)

Step 9: Replace seat and install clip. Now go ride!!!