Gauges ?
Hooking up a Tach would be fairly simple, just wire it into the coil wires...
Reading it, on the other hand, would be a little tricky at speeeeed. Perhaps a "shift" light, programmed to flash at a pre-determined rev limit would be a little more user friendly.
Fuel pressure would be the same deal, just need to tap in somewhere...
Quite a few companies (ie: Autometer) offer mounting cups for their smaller guages...if this is what you're looking for, check 'em out.
Reading it, on the other hand, would be a little tricky at speeeeed. Perhaps a "shift" light, programmed to flash at a pre-determined rev limit would be a little more user friendly.
Fuel pressure would be the same deal, just need to tap in somewhere...
Quite a few companies (ie: Autometer) offer mounting cups for their smaller guages...if this is what you're looking for, check 'em out.
..Here try this..its titled "Add status lights to your Dale.".. http://forums.cannondaler.com/viewtopic.php?t=3732 should be of some help...
I hooked up a tmi tach that uses a simple signal wire wrapped around the head of the coil so there is no cutting in. It measures to 20,000 rpm. It worked but i never got around to mounting it. It is simple very small ,waterproof and internally powered. I did use it for a few years on my 300ex stroker motors to keep from blowing the cranks out of them. I can get some pics if you like. I believe it was around 40 or 50 bucks.