Cannondaleriders

Has anyone tried hooking up a tach or fuel pressure gauge...or any other types of gauges...if so where can I find a good one for my dale. Thanks

..Go to cannondaler.com theres a post on there were someone added some lights...

anyone else

Hooking up a Tach would be fairly simple, just wire it into the coil wires...
Reading it, on the other hand, would be a little tricky at speeeeed. Perhaps a "shift" light, programmed to flash at a pre-determined rev limit would be a little more user friendly.

Fuel pressure would be the same deal, just need to tap in somewhere...

Quite a few companies (ie: Autometer) offer mounting cups for their smaller guages...if this is what you're looking for, check 'em out.

ok thanks...has anyone ever done something like this?

..Here try this..its titled "Add status lights to your Dale.".. http://forums.cannondaler.com/viewtopic.php?t=3732 should be of some help...

I dealt with Autometer a year or so ago to see if they could figure out how to wire a tach. No dice. Couldn't figure out how to pick up the signal. Maybe now that there are so many people that are more saavy on this board, someone could figure it out.

Marc

anyone else have some ideas ?

I hooked up a tmi tach that uses a simple signal wire wrapped around the head of the coil so there is no cutting in. It measures to 20,000 rpm. It worked but i never got around to mounting it. It is simple very small ,waterproof and internally powered. I did use it for a few years on my 300ex stroker motors to keep from blowing the cranks out of them. I can get some pics if you like. I believe it was around 40 or 50 bucks.

post the pics man ive been looking for a very small tach.